Filter
Top Products
23
8
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION REF.
No power comes ON.
•Bad connection to the power supply. •Check the connection to the transceiver. p. 18
No sound comes from
the speaker.
•Squelch level is too deep.
•Volume level is too low.
•Speaker has been exposed to water.
•Set squelch to the threshold point.
•Set [VOL] to a suitable level.
•Drain water from the speaker.
p. 8
p. 8
—
Transmitting is impossi-
ble, or high power can-
not be selected.
•Some channels are for low power or re-
ceive only.
•The output power is set to low.
•Change channels.
•Push [HI/LO] to select high power.
pgs.
6, 24
p. 8
Scan does not start. •“TAG” channel is not programmed. •Set the desired channels as “TAG” chan-
nels.
p. 13
No beep sounds. •Beep tone is turned OFF. •Turn the beep tone ON in SET mode. p. 15
Receive signal cannot
be understood.
•Optional voice scrambler is turned OFF.
•Scramble code is not set correctly.
•Turn the optional voice scrambler ON.
•Reset the scramble code.
p. 10
p. 16
0 IC-M501EURO_3.qxd 03.7.29 15:26 Page 23