Filter
Top Products
6
SET MODE
14
Push
16
Beep tone
Beep
ATIS check
ATIS check
Scan mode
Scan mode
Scan resume timer
Scan timer
Dual/tri watch
DUAL/TRI
LCD contrast
LCD
contrast
Internal speaker
Internal
speaker
Scrambler code
Scrambler
code
Scrambler unit
Scrambler
■ Set mode programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: beep tone function, scan mode (normal/pri-
ority), scan resume timer, dual/tri watch, LCD contrast, scram-
ble code, scrambler unit, internal speaker and ATIS code.
Available functions may differ depending on versions.
q Turn power OFF.
w While pushing [16], turn power ON to enter set mode.
e After the display appears, release [16].
r Push [16] to select the desired item, if necessary.
t Rotate the channel selector to select the desired condition
of the item.
y Turn power OFF, then ON again to exit set mode.
•SET MODE CONSTRUCTION
0 IC-M501EURO_3.qxd 03.7.29 15:26 Page 14