Filter
Top Products
36
Troubleshooting guide
Symptom Cause Solution
No power
The car ignition is not on.
The fuse is blown.
If the power supply is properly connected
to the car accessory switch the ignition
key to “ACC”.
Replace the fuse.
Disc cannot be loaded. Presence of disc inside the player. Remove the disc in the player then put a
new upward.
Disc cannot be read. (LCD
shows “ERROR2”)
Inserting the disc in upside down.
Compact disc is extremely dirty or
defective.
Temperature inside the car is too
high.
Insert the compact disc with the label
facing upward.
Clean the disc or try to play a new one.
Cool off until the ambient temperature
returns to normal.
SD/MMC cannot be read.
(LCD shows “ERROR8”)
Metal interface is rusty, extremely
dirty or defective.
Clean the metal interface or try to play a
new one.
USB cannot be read.
(LCD shows “S-STOP”)
Metal interface is rusty, extremely
dirty or defective.
Clean the metal interface or try to play a
new one.
No sound Volume is in minimum.
Wiring is not properly connected.
Adjust volume to a desired level.
Check wiring connection.
The buttons do not work. The built-in microcomputer is not
operating properly due to noise.
Front panel is not properly fix into
its place.
Press RESET button.
Reinstall the front panel.
Sound skips. The installation angle is more than
30 degrees.
The disc is extremely dirty or
defective.
Adjust the installation angle to less than
30 degrees.
Clean the compact disc/try to play a new
one.