Filter
Top Products
15
Setting other characteristics
During TUNER mode press SEL button and hold for 2 seconds, shortly and repeatedly press SEL button to
select the setting: TA SEEK => PI MUTE => RETUNE L => MASK DPI =>TA VOL => EON TA => DISP
=> REV BEEP.
TA SEEK/TA ALARM
To choose the TA mode, press SEL button for 2 seconds, then press it repeatedly until the display shows TA
SEEK or TA ALARM. Rotate the knob to choose between the TA SEEK and TA ALARM. After choosing,
please leave the unit idle to activate. In TA SEEK mode, the unit will seek for traffic announcement program
when TA is pressed; in TA ALARM mode, no TA/TP is displayed and the alarm is set off.
PI SOUND/MUTE
Press SEL button until the display shows PI SOUND or PI MUTE, then use the knob to choose either PI
SOUND or PI MUTE. PI sound refers to the reception noise when the AF function tries to scan alternative
frequency.
RETUNE S/L - SHORT/LONG
RETUNE refers to the time period the unit allows for radio scan when reception is interrupted. “S” represents a
time period of 30 seconds and “L” represents a time period of 90 seconds.
MASK DPI/MASK ALL
Press SEL button for 2 seconds, then press it repeatedly until the display shows MASK DPI. Rotate the knob to
toggle between MASK DPI and MASK ALL mode, then leave the unit idle to activate. During MASK DPI
mode, the unit will mask only the AF which has different PI, this is the default mode; during MASK ALL
mode, the unit will mask the AF which has different PI and no RDS signal with high field strength.
TA VOLUME:
Rotate the knob or press VOL+/- button to choose the volume level of TA announcements.
EON TA
Rotate the knob to select EON TA LO/EON TA DX mode. If you want to receive information from local
stations only, select EON LO mode. Otherwise, select EON TA DX mode.