Filter
Top Products
9
Functions of controls
General operations
Power button
Press any button to switch the unit on. The display will show a message WELCOME. Press and hold the POWER button to switch
the unit off. The display will show a message GOOD-BYE.
Note: After the unit is off, volume level and radio current settings will be memorized, and when you turn the unit on it will resume the
stored status you set.
Volume control
Rotate the VOL knob (VOL knob / SEL button) on the faceplate. The larger the number shown on the display, the higher the volume
level is.
Audio settings adjustment
Press the SEL button (VOL knob) until the display shows: BAS 0 => TRE 0 => BAL R-L => FAD. Rotate the VOL knob to adjust
each mode.
- BASS/TREBLE: -7, -6, -5,......, 0, +1, +2,......+5, +6, +7
- BALANCE: 7L, 11L,......, L=R, 1R,......,7R
- FADER: 7R, 11R,......, R=F, 1F,......, 7F
NOTE: Adjustments to Bass and Treble will override any preset EQ (Preset Equalizer Curves).
In each mode, the waiting time is about 5 seconds, and the waiting time is over, it returns to the last display mode of radio or disc
playback mode.
Mode selection
Press the TUNING knob to cycle the Play mode: AUX => RADIO => DISK => USB => CARD.
NOTE: USB, CARD, DISK mode will only show on the display when a USB flash memory is inserted into the USB port.
Loudness control
Press the VOLUME knob / SEL button until LOUD OFF is shown. Turn the volume knob to select between ON or OFF.
Mute function
Press the MUTE button to cancel the sound. Press it again or VOL +/ - to resume.
Subwoofer control
Press and hold the BAND/ SUB button to turn the Subwoofer output ON. An external amplifier is required to operate a subwoofer.