Filter
Top Products
10
Beep Sound Off function
Press the VOLUME knob / SEL until Beep On is displayed. Turn the Volume knob to switch between Beep ON and OFF.
Equalizer setting
Press the Volume button, until EQ indication is displayed then rotate the Volume knob to choose between the EQ sound effects:
CLASS => POP => ROCK => FLAT.
Clock display
Press and hold the PTY/CLK button to display the clock, then press and hold the button until the hour blinks on the display.
Rotate the VOL knob to set hours, then press the VOL knob for the minutes to blink and rotate the VOL knob to set.
Press the PTY/CLK button again or leave the unit idle for new setting to effect. Press the PTY/CLK button anytime to view the time
clock display.
Radio operations
BAND selection
Press the BAND / SUB button repeatedly to select your desired radio band during RADIO mode: FM1, FM2, FM3, AM1, AM2. Each
band can store 6 preset stations, for a total of 30 preset memory stations.
Tuning
In Radio mode turn the TUNE button to manually adjust the radio frequency. Rotate the button for 3 seconds once and radio will seek
the next strong and clear frequency station. Repeat to seek more stations in your listening area with a strong signal.
Mono/ Stereo control (in FM radio mode)
Press the VOLUME knob / SEL button until the display shows ST ON or ST OFF (MONO). Turn the VOLUME knob to switch
between ON or OFF.
Improvement of reception of distant stations can be done by selecting MONO operation which may cut down some reception noise.
Automatic store, Automatic scan
During listening to the radio press and hold the F / PS button for more than 3 seconds. The receiver will automatically scan and save
stations for the AM/FM bands.
· Press the F / PS button once in Radio mode to scan the stations in all bands.
Programming tuner stations
You can store up to a total of 30 radio stations in the memory (18 FM, 12 AM), manually or automatically.
· To store a station: