Hitachi bluetooth sound bar Home Theater System User Manual


 
Bluetooth® Connection:
Bluetooth States & Display
There are four Bluetooth connection states, and each is indicated via the Sound Bar’s front
panel Bluetooth LED.
13
Chapter 4 – Connecting the Sound Bar
1. Discoverable (ready to pair)
Sound bar is discoverable and ready to pair with a new
device. The Bluetooth indicator
slowly fades on and off
approximately once every second
. The Sound Bar is
placed into “discoverable mode” by pressing and
holding the Bluetooth button on the remote control for
more than 5 seconds, or by pressing and holding
the Input button on the Sound Bar for more than 5
seconds.
2. Connecting
Sound bar is attempting to connect to a paired device.
The Bluetooth indicator
flashes on and off approximately
twice every second
.
3. Connected
Sound bar is connected to a paired device. The Bluetooth
indicator remains
steadily on
. A connection can only be
initiated by an end user from a device. Once connected, a
device stays connected forever until disconnected by the
user, even if the device goes out of range. If a connected
device comes back into range, the connection will be
automatically re-established. However, if the input has
been set to something other than Bluetooth, the Sound
Bar will not switch to Bluetooth.
4. Disconnected
Sound bar is available to connect to any already-paired
device. The Bluetooth indicator
flashes on and off
approximately once every three seconds.
The Bluetooth light is located on the front
of the Sound Bar below the HITACHI logo.
Note:
It is a good idea to review your audio source device operating manual (smart phone, tablet,
music player, etc.) for detailed information about it’s Bluetooth capabilities and setup.