HP (Hewlett-Packard) KSC-570 Satellite Radio User Manual


 
27
DIGITAL SATELLITE RECEIVER
Menu Guide
7. 0V/12V : Depending on the user’s antenna switch box.
You can choose either 0V/12V.
8. Tone Burst : Depending on the user’s antenna switch box.
(“off”, “SAT A” or “SAT B”)
9. Longitude : Press the NUMERIC buttons and enter the Longitude.
When the OK() button is pressed. It can be toggled
East/West.
10. Latitude : Press the NUMERIC button and enter the Latitude.
When the OK() button is pressed, it can be toggled
North/South.
11. Press the BLUE button to set Drive(Fine Drive or Normal Drive) to
run the motor.
- Fine Drive/Normal Drive : To move the motor,
press LEFT/RIGHT
(/)
button.
- Go to zero : To move the zero position, press OK( ) button.
- East Limit : To set the east limit by current position, press OK( ) button.
- West Limit : To set the west limit by current position, press OK( ) button.
- Clear Limit : To clear the stored limit value, press OK( ) button.
Note:
After the Degree, Longitude and Latitude is enterted accurately.
the DiSEqC Motor will automatically move to the satellite’s position.
After selecting all that is necessary, press RED button to scan the satellite list.
Pop up widow will be displayed.
Select ON or OFF according to your Network.
Select All or FTA Search Type.
Press OK() button and searching will start.
OK
OK
OK
OK
OK
OK
OK
Channel Search
k1.5 500 SAT(Eng) 1/5/06 5:53 PM ˘`27 mac-4 HP LaserJet 5100 Series T