Filter
Top Products
3
MODULUS II HOME THEATER SYSTEM
I
NSTALLING THE
S
ATELLITES
For Shelf Placement
1. Remove the Modulus II satellites from the box. Remove rubber
cover from the base and pull out Allen wrench.
2. Use the Allen wrench to loosen the adjustment screw (as
necessary) to allow the mounting ball on the speaker to turn
freely in the cup restraint.
NOTE: To prevent damage to the mounting ball, do not rotate the
speaker unless the adjustment screw has been loosened.
3. Run speaker wires in through the rear of the base and up
through the speaker wire holes on the left and right sides of
the cup restraint (see page 5, Figure 10 for wire connections).
4. Rotate speaker on its base into the shelf placement position as
shown below.Tighten the adjustment screw with the Allen wrench
(securing the speaker in position) and replace the cover.
Adjustment
Screw
Allen Wrench
Housed
in Base
Rubber
Cover
Mounting Plate Screw
Base
Mounting Plate shown removed from Base.
The Mounting Plate is used to secure the
Modulus II to a surface in a fixed position
such as for wall-mounting or on an
uneven surface.
Speaker
Adjustment Screw
Speaker
Mounting Ball
Cup Restraint
Connector Posts
Speaker
Wire Hole
FIGURE 6
F
IGURE 5
F
IGURE 4
F
IGURE 3