Filter
Top Products
15
MODULUS II HOME THEATER SYSTEM
The pointer on the slider will indicate the correct width setting.
Enter this number in the Width field of the Measurement Template.
In our example,the width is 12.5%.
It is not realistic to expect a perfect fit.Acoustic
measurements encompass the behavior of not only the speakers
but of the room and its contents as well.Reflected energy,
standing waves and ambient noise all add their part. Determining
the best width setting nearly always requires compromise.
Level
This setting will define the amount (level) you want to reduce the
peak, in decibels.
The R.A.B.O.S.level adjustment is limited to attenuation only, and
is adjustable from 0dB to –14dB.After optimization, the
R.A.B.O.S. equalizer will eliminate the largest low-frequency peak;
therefore, the broadband bass level can be increased without
overpowering the midrange frequencies. R.A.B.O.S. applies this
compensation automatically.
You will use the Width Selector as an aid in determining the
correct level setting. Place the Width Selector as described
above and adjust it to the correct width.Observe the first
frequency point on the high-frequency side of the peak that no
longer follows the slope of the Width Selector. In this example
this is 56Hz. Calculate the average level of the readings from
56Hz up to 100Hz; that is, 10 data points in this example.
Whenever your answer has a remainder, always round down
(disregarding the negative [–]) to the next whole number.
In our example, you would enter 9 in the attenuation field.
This may not be the best method in all cases.The next section
contains several other examples.
What You Measure,What To Do
As stated earlier, it is not possible to anticipate the effect of
every possible listening environment.However, most residential
sound rooms share many characteristics,and their dimensions
fall into a range that makes some response irregularities far
more likely than others.On the following pages are examples
of what you may encounter. Following each example is a strategy
for correction. Compare your measurement results with the
following examples. Find the one that best fits your graph and
follow the instructions presented for that scenario.
Remember, when looking for a match, look at the
descriptive characteristics, not any specific frequency or level.
Each of these examples can occur at any frequency, bandwidth
and level. It is unlikely that your test results will be exactly as
depicted in these examples.
Example 1. Single Dominant Peak:
This is the most common result of speaker/room interaction.
Apply the Width Selector as demonstrated in Figure 23. Align the
center line of the Selector over the center of the peak,as shown in
Figure 23. Now adjust the Selector until you have achieved the “best
fit.”The slider now points to the correct bandwidth setting.In this
example,the frequency is 43Hz and the best-fit width is 12.5%.
Fill in the Width and Frequency fields provided on the template.
Determine the appropriate level using the technique described
earlier. In this example,–9dB would be best. Enter the level in the
field provided.
Skip to the “Adjusting the R.A.B.O.S. Equalizer”section on
page 18.
Single dominant peak
56Hz 63Hz 66Hz 72Hz 77Hz 80Hz 85Hz 90Hz 95Hz 100Hz
–9 –10 –8 –9 –10 –9 –8 –10 –10 –9 –
92 ÷ 10 = –9.2
FIGURE 25