Harman-Kardon II Speaker System User Manual


 
6
MODULUS II HOME THEATER SYSTEM
S
UBWOOFER
C
ONTROLS
Rear Panel
Front Panel
ª
LR
POWER
ON
OFF
ON
OFF
180°
0°
Freq.
Level INPUT
R.A.B.O.S.™
Controls
R.A.B.O.S.
PHASE
LOW PASS
LFE
Width
™¡
§
£
¢
FUSE
T5A L/250V
AC 120V~60Hz
75 Watts
Modulus MSW-II
This unit is designed to become quite warm,
during normal operation.
NRTL/C
CSA22-2 NO. 1
UL 1492
¡
R.A.B.O.S. On/Off Switch
Center-Frequency Adjustment
£
Bandwidth Adjustment
¢
R.A.B.O.S. Level
Phase Switch
§
Low-Pass Filter Selector
Line-Level Inputs
Power Switch
ª
Subwoofer Level Control
A Few Suggestions
We recommend that you do not operate your speakers or
subwoofer with the bass, treble and loudness controls set to
full boost.This will place undue strain on your electronics and
speakers and could damage them.
The volume control setting on your processor/preamp or receiver
is not a specific indication of the overall loudness level of the
speakers.The only important consideration is the loudness level
at which the system can be played, regardless of where the
volume control is set.
Always turn down the volume control setting on your processor/
preamp or receiver when changing a cassette or CD, or switching
inputs to AM or FM operation. Excessively loud transients (clicks
or popping sounds) can damage the satellite speakers and
possibly the subwoofer.
Important!
Whenever changing cables, pulling plugs, etc.,ALWAYS TURN OFF
ALL EQUIPMENT, including the subwoofer.This prevents transients
from entering the speakers and prevents electrical energy from
reaching you.Keep all connections out of the reach of children.
Room Adaptive Bass
Optimization System
(R.A.B.O.S.) Controls
(See p.9 for complete
R.A.B.O.S. instructions.)