Harman-Kardon AVR 70C Stereo Receiver User Manual


 
AVR 700/AVR 70/AVR 70C
18
Advanced Functions, continued
Sleep Timer
The sleep timer sets the AVR to play for up to 90 minutes and then turn off automatically.
Press the Sleep button on the remote, and the time until turn-off will be displayed on
the front-panel Message display The available settings are 30 min., 60 min., 90 min.
and OFF.
When the sleep timer has been set, a small crescent-moon icon will appear on the front-
panel display.
If you press the Sleep button after the timer has been set, the remaining play time will be
displayed. Press the Sleep button again to change the play time.
Processor Reset
If the AVR behaves erratically after a power surge, first turn off the front-panel Main
Power switch and unplug the AC power cord for at least 3 minutes. Plug the cord back
in and turn the AVR on. If this procedure doesn’t help, reset the AVR’s processor as
described below.
NOTE: Resetting the processor will erase all user configurations, including speaker and
level settings, and tuner presets. After a reset, reenter all of these settings from your
notes in the Appendix worksheets.
To reset the AVR’s processor:
1. Press the front-panel Standby/On switch to place the unit in the Standby mode (the
Standby Indicator LED will turn amber).
2. Press and hold the front-panel Standby and Memory/Folder buttons until the RESET
message appears on the front-panel Message display.
3. Press the Memory/Folder button again to reset the AVR’s processor.
If the AVR does not function correctly after a processor reset, contact an authorized
Harman Kardon service center for assistance. To locate an authorized service center,
visit our Web site at www.harmankardon.com.
Memory
If the AVR is unplugged or experiences a power outage, it will retain your user settings
for up to two weeks.