Filter
Top Products
ZONE 2 REMOTE CONTROL FUNCTIONS 13
ENGLISH
Zone 2 Remote Control Functions (Zone 2 Remote Control only with AVR 355)
A Power Off
B AVR Settings
C Back/Exit Button
D Source Selectors
E Menu Navigation Buttons
F Volume Up/Down
G Mute
H Transport Controls
I Sleep Button
J Settings Info Button
K Menu Button
L OK Button
M Zone Select Buttons
NOTE: The Zone II.4 remote may be used in
either the same room where theAVR is located,
or it may be used in a separate room with an
optional infrared sensor that is connected to the
AVR’s Zone 2 IN input jack
V
. When it is used
in the same room as theAVR, it will control the
functions of the AVR or any compatible
Harman Kardon products in that room.When it
is used in a separate room via a sensor
connected to the Zone 2 IN Jack
V
, the but-
tons for power,input source,volume and mute
will control the source and volume for the sec-
ond zone, as connected to the Zone 2 Out
Jacks
b
. (See page 35 for complete information
on using the Multiroom system.)
The Zone II remote may be used in either the
same room where the AVR is located, or it may
be used in a separate room with an optional
infrared sensor that is connected to theAVR’s
Zone 2 input jack
V
or an A-BUS device.
A Power Off:When used in the room where
the AVR is located, press this button to place the
unit in Standby.When it is used in a remote
room with a sensor that is connected to the
Zone 2 jack
V
, this button turns the Multi-
Room system off.
B AVR Settings: Open theAVR settings info
screen with this Button.
C Back/Exit Button: Press this button to go
back to the previous Menu or to exit a Menu.
D Source Selectors: Press these buttonsto
selectan input source for theAVR 355/AVR 255.
E Menu Navigation Buttons: Use these
buttons to move Up, Down, Left or Right when
using the Menu system of the AVR 355/AVR 255.
F Volume Up/Down: When used in the
room where the AVR is located, press this button
to raise or lower the volume in that room.When
it is used in a remote room with a sensor that is
connected to the Zone 2 Jack
V
, this button
will raise or lower the volume in the remote
room.
G Mute: When used in the room where the
AVR is located, press this button to temporarily
silence the unit.When it is used in a remote
room with a sensor that is connected to the
Zone 2 Jack
V
, this button will temporarily
silence the feed to the remote room only. Press
the button again to return to the previous
volume level.
Important Note: No matter in which room the
Zone II remote is used, as with the main remote
it is important to remember to press the Source
Selector button D that corresponds to the
unit you wish to operate befor you change the
device to be controlled.
H Transport Control Buttons: These
buttons do not have any functions for theAVR,
but they are programmed for the forward/
reverse play operation of a wide variety of
Harman Kardon CD or DVD players, and audio or
video- cassette recorders.
A
B
C
D
E
F
H
G
I
J
K
L
M