Filter
Top Products
1. Connect signal from source to CH B input.
2. Biamp/Stereo switch not active (Stereo/Mono switch
overrides this switch when in mono/70V/100V mode).
3. Move Stereo/Mono switch to 100V mode.
4. Select 100V load, both channels.
5. Connect parallel array of 100V transformer-equipped
speakers across the red terminals of the 5-way binding
posts. CE units: Wire SPEAKON as shown above and
connect to CH A output.
6. CH B input sensitivity controls 100V mono output level.
Amplifier will clip at 100Vrms level.
1. Connect signal from source to both CH A and CH B inputs.
2. Move Biamp/Stereo switch to Stereo mode.
3. Move Stereo/Mono switch to Stereo mode.
4. Select 8Ω speaker load for each channel.
5. Connect parallel array of 70V transformer-equipped
speakers (up to 700W per channel) to 5-way binding
posts. CE units: Connect as shown above for Dual
SPEAKONs or Single 4-Wire SPEAKON.
6. Adjust CH A and CH B level controls independently.
100V MONO MODE
70V STEREO MODE
CE SPEAKON
Connector
Wiring
CE SPEAKON
Connector
Wiring
Connect to CH A output
– 20 –