Filter
Top Products
ENGLISH
13
Antennas
The device is equipped with an integrated antenna for the reception of MW (medium wave)
stations.
1 Plug the rooftop antenna cable into the »FM ANT« antenna socket on the hi-fi.
Note:
If no rooftop aerial system is available, use the wire antenna supplied. This antenna pro-
vides reasonably good reception of local FM (VHF) stations. Do not shorten the wire
antenna.
Connecting the loudspeakers
1 Plug the loudspeaker cables into the »SPEAKERS + R – – L +« terminals on the hi-fi
system.
Connect the cables marked in red to the red terminal.
Connecting the headphones
1 Insert the headphone plug (ø 3.5 mm) into the »PHONES« socket on the front of the
hi-fi system.
– The loudspeakers of the hi-fi system are switched off.
Connecting the power cord
Note:
Check that the mains voltage on the type plate (on the back of the hi-fi system) corre-
sponds to your local mains supply.
The only way to disconnect the hi-fi system from the mains supply is to pull out the plug.
1 Plug the »AC ~« power cord into the wall socket.
Connecting an external device
1 Connect the audio output sockets of the external device (for example a television or DVD
player) to the »R AUDIO IN L« sockets on the hi-fi system using a cinch cable.
Note:
Switch the hi-fi system off before you connect external devices. Make sure the stereo
channels are properly connected:
R = right channel (red), L = left channel (white).
Inserting the memory card
The hi-fi Player supports MMC, SD and MS memory cards.
1 Switch off the hi-fi.
CONNECTION AND PREPARATION ___________