Grundig UMS 2020 Stereo System User Manual


 
9
ENGLISH
CONNECTION AND PREPARATION
---------------------------------------
Inserting a memory card
The hi-fi system supports SD/SDHC and MMC
memory cards.
Caution:
7
The hi-fi system must be switched off while
the memory card is being inserted. If it is not
switched off, data can be lost.
SOURCE
PRESET
VOLUME
UBS
OPEN
UMS 2020
SD CARD USB
1 Switch off the hi-fi system by pressing »8«.
2 Insert the card carefully into the »SD« card slot
until it latches into place.
Notes:
7
Do not use excessive force when inserting
the memory card. Only apply slight pres-
sure.
7
The memory cards are resistant to dirt and
moisture, but may only be inserted into the
hi-fi system in a dry and clean condition.
7
Never remove memory cards during opera-
tion. This can damage the memory card.
This type of damage will invalidate your
warranty.
Removing the memory card
Caution:
7
The hi-fi system must be switched off while
the memory card is removed. If it is not
switched off, data can be lost.
1 Remove the memory card from the card slot by
pressing the card inwards slightly until the latch
is released. Then pull out the card.
Connecting the headphones
SOURCE
PRESET
VOLUME
UBS
OPEN
UMS 2020
SD CARD USB
1 Insert the headphone plug (ø 3.5 mm) into
the »U« socket on the front side of the hi-fi
system.
– The loudspeakers of the hi-fi system are
switched off.
Note:
7
Excessive sound pressure from the ear-
phones or headphones can cause hearing
loss.