Filter
Top Products
11
ENGLISH
SETTINGS
---------------------------------------------------------------------------------------------------------------------------------------
Setting the clock
The first time you connect the hi-fi system to the
mains, it switches to standby.
1 In standby mode, press and hold »PROG« on
the remote control for 2 seconds.
– Display: »12 H« or »24 H«.
2 Press »3« or »4« on the hi-fi system or
»5« or »6« on the remote control to select
the hour format (12 or 24 hours) and confirm
with »PROG«.
– Display: The clock digits for the hours flash.
3 Select the hours with »3« or »4« on the
hi-fi system or with »5« or »6« on the remote
control and confirm with »PROG«.
– Display: The clock digits for the minutes flash.
4 Select the minutes with »3« or »4« on
the hi-fi system or with »5« or »6« on the re-
mote control and confirm with »PROG«.
– Display: the current time.
Switch off or on the RDS time
synchronisation
Some RDS stations transmit an RDS time signal.
If the selected RDS station transmits time infor-
mation, the time is updated automatically, if you
have set »CT ON«. This takes about five minutes.
1 Switch on the hi-fi system from standby mode
by pressing »8« or »SOURCE«.
2 Select the input source TUNER with »SOURCE«
on the hi-fi system or with »TUNER« on the re-
mote control.
3 Press and hold »DISPLAY« on the remote
control for 2 seconds.
– Display: »CT ON« flashes.
4 Switch the RDS time synchronisation off or on
with with »3« or »4« on the hi-fi system
or »5« or »6« on the remote control.
Notes:
7
The current time is displayed in standby
mode – with reduced brightness.
7
The time must be reset after a power failure
or after disconnecting from the mains.
Tuning and storing radio stations
You can store up to 30 stations in the FM and
10 stations in the AM frequency range on pre-
sets.
Note:
7
For the best FM (VHF) reception, it is suffi-
cient to direct the wire antenna accordding-
ly.
Programming radio stations
1 Switch on the hi-fi system from standby mode
by pressing »8« or »SOURCE«.
2 Select the input source TUNER by pressing
»SOURCE« on the hi-fi system or by pressing
»TUNER« on the remote control.
3 Select the desired wave range (FM or AM)
by pressing »SOURCE« on the hi-fi system or
»TUNER« on the remote control.
4 Set the radio station by briefly pressing »3«
or »4« repeatedly.
– Display: the frequency changes in steps of
50 kHz;
or
press and hold down »3« or »4« until
the frequency changes to rapid run-through.
5 To store the radio station, press »PROG«, se-
lect preset by pressing »+ PRESET -« on the
hi-fi system or by pressing »V« or »Λ« on the
remote control and confirm with »PROG«.
6 To search and save more radio stations, repeat
steps 3 to 5.