Filter
Top Products
POWER SUPPLY
AC ADAPTER
Keep curtains and other flammable materials out of
The SATELLIT 800 MILLENNIUM receiver is supplied direct contact with the AC ADAPTER to avoid overheat
with an auto-switchable AC ADAPTER to power it ing.
indoors. The AC ADAPTER is designed to be plugged
into a wall outlet that supplies nominal 120 VAC, 60 Hz
GRUNDIG assumes no responsibility for damage
or nominal 230 VAC 50 Hz power.
due to operation with an AC adapter other than the
The AC adapter is supplied with a North American type
connector. To use the unit in countries using a European
one supplied with this unit.
BATTERY OPERATION AND INSTALLATION
type connector, plug the North American connector into The SATELLIT 800 MILLENNIUM receiver is designed
the US to Europlug adapter that is provided. to operate from either the supplied AC ADAPTER or
Connect the output connector of the AC adapter to the
from six "D" cell batteries (not supplied). NOTE: Check
the batteries periodically for leakage. IF UNIT IS TO
9 VDC, 1 amp connector on the back of the receiver. BE STORED OR OTHERWISE NOT USED FOR AN
Inserted batteries are automatically disconnected as EXTENDED PERIOD OF TIME, REMOVE THE BAT
soon as the AC adapter is plugged in to this connector. TERIES TO PREVENT CORROSION AND POSSIBLE
DAMAGE TO THE RECEIVER.
Battery Installation
(1) Position receiver with the back panel towards you.
(2) Remove battery access cover by pressing on the
corrugated area in the center of the cover and sliding it
to your left as far as it will go. Then gently pull it straight
out from the rear panel.
(3) Place 6 "D" cell alkaline type batteries into holder.
Make sure the batteries are in the proper polarity posi
tion as illustrated in Figure 1.
(4) Replace access cover by placing it over the left side
of the opening and then sliding it to the right.
NOTE:
The SATELLIT 800 MILLENNIUM does not rely on the
batteries for retention of memory channels. To ensure
that clocks and timers are maintained following the loss
of AC power or battery removal, the receiver must first
be connected to a source of AC power or have batteries
installed for a minimum of 10 minutes. If power is lost
after this minimum 'charge' time, clocks and timer
settings are maintained for a time period of approxi
mately 30 minutes.
8