Grundig 800 Stereo System User Manual


 
20
SCAN FUNCTIONS
SCAN DESCRIPTION
The SATELLIT 800 MILLENNIUM provides a time scan
function of programmed memory channels using the
button. Scan will begin and end within a 10
channel block of programmed memory channels as
indicated by the most significant digit of the selected
memory channel number.
The receiver will stop at each programmed memory channel
within the block for 5 seconds and then increment to the next
memory channel. Memory channels that are programmed to
be skipped will not
be scanned. The 'SCAN' symbol will be displayed for the
duration of the scan action. Scanning will continue until the
'SCAN' button is pressed again.
Example for SCAN:
Suppose that memory channels 30 through 39 are
programmed and it is desired to scan these channels. To
initiate the scan action, press the
button
followed by the two-digit channel number entry (can enter 30
through 39 for this example).
Press the button. The receiver will begin scanning
from the selected memory channel and continue scanning in
sequence: '30'- '31' -'32' - etc.
Press the
button again to stop the scanning action.
Note that if channels 29 and 40 were stored, they would not
be included in a scan of the channels starting with a '3' as
the most significant digit of the channel number.
MEMORY CHANNEL SKIP
A memory channel can be skipped for scan operations.
While in the MEMORY mode, press the'(
SKIP I' button.
The display will indicate that the 'SKIP' function has been
stored for that particular memory channel number. An 'S'
will be displayed to the right of the memory channel number
on the display. Repeat the same sequence as described to
remove the 'SKIP' function from a memory channel number.
Example for MEMORY CHANNEL 'SKIP':
Refer to the previous example on this page. Suppose it is
desired to skip the memory channel number '34' from the
scan action:
From the normal variable frequency tuning and reception
mode (VFO) or from the Memory mode, press the
button followed by the two-digit number '34'.
Press the
button. An 'S' will illuminate to the right of
the displayed '34'. When the scan action is initiated, all
channel numbers 30 through 39, except 34, will be
scanned. Note that the memory contents of channel 34 still
remain. It is skipped over only in the scan sequence.
To allow channel 34 to again be included in the scan
sequence, press the
button followed by the two-
digit number '34'.
Press the
button to remove the 'SKIP' function from
channel 34 for this example. The 'S' indicator in the display
will turn off.