Filter
Top Products
16
Basic operations
The system turns off automatically when the specified
period of time has passed.
Press SLEEP with SHIFT pressed.
Each time you repeat the procedure, the shut-off time
changes.
Example:
To check the remaining time
Press SLEEP once with SHIFT pressed.
To change the remaining time
Press SLEEP repeatedly with SHIFT pressed.
To cancel
Press
SLEEP
repeatedly with
SHIFT
pressed, until “SLEEP
– –
”
appears.
• Turning off the power also cancels the Sleep Timer.
1 Press SPK-LEVEL to show the
target speaker indication on the
display window.
Each time you press the button, the indication of the
speakers changes as follows:
2 Press LEVEL +/– to adjust the
output level from –6 to 6.
NOTE
• You can also make adjustments by using the setup menu
shown on the TV screen. (See page 34.)
• The adjustments take effect for all sources.
The system can be accommodated to your TV’s scan mode.
NOTE
• To use the system in the progressive mode, it is required that
the center unit is connected to the TV by using a component
video cord (not supplied). (See page 11.)
7While DVD or USB MEMORY is selected as the source
and before playback
1 Press and hold SCAN MODE for 2
seconds.
The current setting appears on the display window.
2 Press Cursor 3/2 to select the
desired mode.
• NTSC: Select when your TV supports the NTSC
interlaced video input only.
• NTSC PRG: Select when your TV equipped with
component jacks supports the NTSC progressive
video input.
• PA L : Select when your TV supports the PAL
interlaced video input only.
• PAL PRG: Select when your TV equipped with
component jacks supports the PAL progressive video
input.
You can get better picture quality in NTSC PRG, PAL
PRG mode than in NTSC, PAL mode.
3 Press ENTER while the selected
mode is displayed.
When “NTSC PRG” or “PAL PRG” is selected, the
PROGRESSIVE indicator lights on the display window.
NOTE
• Although the picture may be distorted when you press
ENTER, this is not a malfunction of the system.
Sleep Timer [SLEEP]
Adjusting the output level of
the front/center/surround
speakers and subwoofer
FRNT L (Front left speaker) Z FRNT R (Front right
speaker) Z CENTER (Center speaker) Z SURR L
(Surround left speaker) Z SURR R (Surround right
speaker) Z SUBWFR (Subwoofer) Z (back to the
beginning)
minutes
Changing the scan mode
• There are some progressive TVs and High-
Definition TVs that are not fully compatible with
this system, resulting in an unnatural picture when
playing back a DVD VIDEO in the progressive scan
mode. In such a case, change the scan mode to
“PAL” or “NTSC”.
• All JVC progressive TVs and High-Definition TVs
are fully compatible with this system.
See page 14 for button locations.
EN_THP7-P3[U]4.book Page 16 Tuesday, April 4, 2006 5:08 PM