Filter
Top Products
54
Chapter 3: Using the Receiver
www.gateway.com
To recall channel levels from memory:
1 Press the SETUP button on the receiver for more than 2 seconds to enter
Setup mode.
2 While in Setup mode, repeatedly press the SETUP button on the receiver
until
P CALL displays.
3 While displaying P CALL, press the ADJUST up and down buttons on the
receiver to select
P CALL.
4 Press the DECODING button on the receiver to confirm.
You can also work with channel levels using your remote control and the OSD.
For more information, see “OSD menus and options” on page 66.
Adjusting the LFE level
You can adjust the Low Frequency Effect (LFE) levels in Dolby Digital, DTS, and
MPEG program sources.
To adjust the LFE level:
1 Press the SETUP button on the receiver for more than 2 seconds to enter
Setup mode.
2 While in Setup mode, repeatedly press the SETUP button on the receiver
until
DD L displays.
3 While displaying DD L, press the DECODING button on the receiver to cycle
between the available modes: Dolby Digital LFE (
DD L), DTS LFE (DTS L),
and MPEG LFE (
MP L).
4 While displaying the LFE mode you want, press the ADJUST up and down
buttons on the receiver to adjust the level.
You can also adjust the LFE level using your remote control and the OSD. For
more information, see “OSD menus and options” on page 66.