Filter
Top Products
52
Chapter 3: Using the Receiver
www.gateway.com
To select stereo mode:
■ Press the Stereo button on the remote control to cancel surround mode
and switch to stereo mode.
If Stereo mode is applied to a multi-channel DTS, Dolby Digital, or MPEG signal,
the signal is downmixed to a 2-channel downmix (
2-CH DOWNMIX) mode,
allowing the multi-channel signal to be reproduced through only two speakers
or through headphones.
To cancel Stereo mode and switch back to surround mode, use the
DSP Mode
buttons on your remote control.
Adjusting the channel levels
You can adjust your channel levels using test tones or manually. Ideally you
should use the test tone method first and then make any additional adjustments
through the manual process.
To adjust channel levels using test tones:
1 Press the T. Tone button on the remote control. The test tone plays out of
each channel in a 2-second cycle. If a speaker setting is
N, the test tone
will not play out of that channel.
2 Press the CH/LEVEL up and down buttons on the remote control to adjust
the level for each channel.
3 Press the T. Tone button on the remote control to cancel the test tone.