Filter
Top Products
34 GPSMAP 400/500 Series Owner’s Manual
Viewing Information
Selecting the Number of Engines Shown in Gauges
The engine gauges can show information for up to four engines.
1. From the Home screen, select Information > Dashboard >
Engine > MENU > Gauge Setup > Engine Selection > Num.
Engines.
2. Select the number of engines.
3. Select Back.
To select the engines for which information appears in the gauges,
select Edit Engines and complete steps 2 through 5 of “Selecting
the Engines Shown in Gauges” (following section).
Selecting the Engines Shown in Gauges
You must manually select the number of engines shown in the
engine gauges (page 34) before you can select the engines for which
information appears in the gauges.
1. From the Home screen, select Information > Dashboard >
Engine > MENU > Gauge Setup > Engine Selection > Edit
Engines.
2. Select First Engine.
3. Select the number of the engine for which you want to view
information in the rst gauge or bar.
For example, if you select “3,” the rst engine bar shows
information for the engine identied as “Engine3” on the NMEA
2000 network.
4. Repeat step 3 for the second, third, and fourth engine bar, as
needed.
5. Select Back.
Viewing Engine Gauges
To view engine information, your chartplotter must be connected to
a device capable of measuring fuel level, fuel ow, or both.
From the Home screen, select Information > Dashboard >
Engine.
Fuel gauge
Fuel ow
Conguring Engine Gauges
The amount of fuel on board can be represented by either the total
fuel level (numeric) or by individual tank level (graphic).