Filter
Top Products
To connect to an unbalanced preamplifier (eg G01 Control Unit)
G01 Control Unit
PRE OUT
AU
DIO LEAD
AU
DIO LEAD
G56/G57
OFF
• Switch the BRIDGE MODE switch to the OFF position.
• Connect the UNBALANCED sockets on the power amplifier to the
outputs from the preamplifier.
• Switch the channels to the UNBALANCED position.
You should either use a twin-screened audio cable, or a pair of
single-screened audio cables.
To connect to a balanced preamplifier (eg G02 Balanced Control Unit)
G02 Balanced Control Unit
XLR LEAD
XLR LEAD
BALANCED
MAIN OUT
G56/G57
OFF
• Switch the BRIDGE MODE switch to the OFF position.
• Connect the BALANCED sockets on the power amplifier to the
balanced outputs from the preamplifier, using XLR cables.
• Switch the channels to the BALANCED position.
I n s t a l l i n g
t h e p o w e r
a m p l i f i e r
1 1
G Series Power Amplifier 11 9/5/06 11:59:44 am