Filter
Top Products
VNS104 Software Installation
Before Installing the Software
Before starting the VNS104 installation, the Enterprise Controller must be updated with
compatible rmware (see VN-Matrix Device Compatibility on page3).
Once the controller has been updated, be certain you have the following items:
From the VNS104 Software Case From the Enterprise Controller (EC)
• Device ID • EC IP address
• Device checksum • EC port (default = 5432)
NOTE: The Enterprise Controller may need to be updated with compatible
firmware (see VN-Matrix device compatibility on page 3).
Installing the VNS104 Software
1. Ensure that the PC running the VNS104 software is connected to a network.
2. Insert the application disc into the disk drive of the PC.
3. Locate the VNS104 installation file, VNS 104SetupV1.0.0.15.exe, and double-click
on it.
4. The next screen is different depending on whether this is the first installation of the
VNS104 software, an update, a repair attempt, or if you are removing the software.
• If this is the first installation of the VNS104 software, the following screen
appears (see figure 2).
Figure 2. VNS104 Splash Screen
The splash screen remains for a few seconds, then the installion program begins
with step 7.
VNS104 Multi‑Stream Decoder • Introduction and Installation 4