Filter
Top Products
Through-furniture mounting
The interface can be mounted through a desk or other furniture using an optional Extron
MBD 129 through-desk mounting kit (part #70-077-02). Mount the unit through a desk or
table as follows (figure 8):
Figure 8. Through-desk Mounting
1. Loosely attach the mounting brackets to the interface using the four machine screws
and washers supplied with the mounting kit.
2. Hold the interface against the inside of the surface through which it will be mounted.
Mark the four screw holes and the table material to be removed on the inside of the
surface to which you are mounting the device.
3. Remove the table material. Test the fit by inserting the front of the device through the
hole. If necessary, use a rasp or coarse file to enlarge the hole.
4. Drill four pilot holes, each 3/32 inch in diameter by 1/4 inch deep, where you made
marks.
5. Using the provided four wood screws, secure the brackets to the mounting surface.
6. Slide the interface up and down in the mounting brackets until the face of the unit is at
the desired height. Tighten the screws that secure the brackets in place.
If the screws are inaccessible to a screwdriver:
a. Mark the location of the brackets relative to the screws.
b. Remove the interface from inside the furniture.
c. Tighten the screws.
d. Replace the unit inside the surface (step 5).
DVI-RGB 200 • Reference Information 13