Filter
Top Products
DVI DA Plus Series • Installation and Operation
Installation and Operation
2-2
Installation Overview
All three distribution ampliers can be mounted on tabletops,
under furniture, and in racks by following these steps:
1. Ensure that the input sources, the distribution amplier and
the output display(s) are all turned off and all power sources
and signal cables are disconnected.
2. Mount the unit as described in "Mounting the Distribution
Amplier", below.
3. Connect the cables (see page 2-9).
4. Plug in the power supply, turn on the display devices and,
nally, turn on the input devices (see page 2-11).
Mounting the Distribution Amplifier
All three of these units can be mounted in racks, under furniture
or on tabletops.
Tabletop placement
Attach the four provided rubber feet to the bottom of the unit
and place it in any convenient location.
Rack mounting
UL guidelines for rack mounting
The following Underwriters Laboratories (UL) guidelines are
relevant to the safe installation of these products in a rack:
Elevated operating ambient temperature —1. If the unit
is installed in a closed or multi-unit rack assembly, the
operating ambient temperature of the rack environment
may be greater than room ambient temperature. Therefore,
install the equipment in an environment compatible with
the maximum ambient temperature (Tma: +122 °F, +50 ° C)
specied by Extron.
Reduced air flow —2. Install the equipment in the rack so that
the equipment gets adequate air ow for safe operation.
Mechanical loading —3. Mount the equipment in the rack so
that uneven mechanical loading does not create a hazardous
condition.
Circuit overloading —4. Connect the equipment to the supply
circuit and consider the effect that circuit overloading might
have on overcurrent protection and supply wiring. Give
appropriate consideration to the equipment nameplate
ratings when addressing this concern.