Filter
Top Products
P/2 DA2 WM/EC
Controls and Installation
P/2 DA2 WM/EC
Controls and Installation
2-9
3. Slide the audio cable connector into the audio output
connector on the interface.
Installing Architectural Adapter Plates
The P/2 DA2 WM AAP may have up to 4 optional adapter
plates and the P/2 DA2 EC AAP can have up to 3 adapter
plates. The adapter plates provide a convenient method of
adding various connectors for specific audio and video
requirements. The adapter plates must be ordered
separately and must be attached to the faceplate and cabled
before attaching the WM AAP model to the wallmount
bracket or the EC AAP model to the Euro Channel. See
figure 2-7.
1. Insert the adapter plate captive screws through the
front faceplate holes. Secure the adapter plate using
the supplied washers and nuts.
Figure 2-7 — Installing adapter plates
2. Attach the output cables to the back side of the
adapter plate. Some adapter plates may require that
conductors be soldered to the connectors. Attach foil
and braided shields to ground connections.
2-8
Tip (+) Sleeve
Tip (+)
Ring (-)
Sleeve
Balanced Output
Tip
Ring
Sleeve (s)
Tip
Ring
Figure 2-6 — Fastening captive screws
3. Slide the audio cable connector into the audio output
connector on the interface.
Balanced audio
To attach the interface to a balanced audio system, do the
following:
1. Attach the audio cable to a balanced speaker input
connector (tip, ring, and sleeve).
2. Attach the audio cable to the audio cable connector
(Extron part number 10-319-10). Fasten the captive
screws inside the audio cable connector as shown in
figure 2-6.
Connect the sleeve(s) to ground (GND).
Connecting the sleeve(s) to a negative (-)
terminal will damage audio output circuits.
Controls and Installation, cont’d
#4-40 Nut w/ Captive
Washer
P/2 DA2 EC
(up to 3 Plates)
P/2 DA2 WM
(up to 4 Plates)
Adapter Plate
INPUT
AUTO POWER
ID PIN 4
UNITY
GAIN/PEAKING
100%
50%
ID PIN 11
AUDIO
BUFFERED
LOCAL MONITOR
P/2 DA2 WM
AUTO POWER
P/2 DA2 EC AAP
ID PINS
100%
UNITY
50%
GAIN/
PEAKING