24
Troubleshooting (2)
Digital audio recording is not possible on another device
e
Copy-prohibit material cannot be copied digitally.
Noticeable difference in CD and Super Audio CD’s volume.
e
That is because CDs and Super Audio CDs use different
recording methods.
Word Sync
The display shows “No Word!”
e
The word sync mode is selected, but there is no clock
source. Turn the word sync mode off (see page 17).
e
No word clock is being received. Check cables, connections,
and settings of the clock generator.
The display shows “WRD UNLCK!”
e
Invalid word sync signal is received. Check the setting of the
clock generator.
i.LINK (AUDIO) terminal
The i.LINK (AUDIO) terminals will become available after a future
hardware upgrade (charged).
No multi-channel audio output
e
Super Audio CDs may have more than one playback area,
not all of which contain multi-channel audio data. Choose
another playback area (see page 15).
e
Set “Analog Out” to “Multi ch” (see page 21).
e
Change the speaker configuration if necessary (see page
22).
Overall volume is low, or balance between speakers is
strange
e
A speaker’s level (or that of a pair of speakers) has been set
up too low or too high in the speaker setup (see page 22).
Correct the levels.
e
When configuring speaker sizes, making “small” and “off”
settings on speakers other than the subwoofer can affect
the subwoofer volume. Adjust the level on the subwoofer
itself (see page 22).
If normal operation cannot be obtained, unplug the power
cord from the outlet and plug it again. This resets the
internal micro-computer which can be disturbed during
electrical storms, power interruptions, et cetera.
Beware of condensation
When the unit (or a disc) is moved from a cold to a warm
place, or used after a sudden temperature change, there is a
danger of condensation; vapor in the air could condense on
the internal mechanism, making correct operation impossible.
To prevent this, or if this occurs, leave the unit turned on for
one or two hours. Then the unit will stabilize at the
temperature of its surroundings.
Maintenance
If the surface of the unit gets dirty, wipe with a soft cloth or
use diluted neutral cleaning liquid. Be sure to remove any
fluid completely. Do not use thinner, benzine or alcohol as
they may damage the surface of the unit.
For European customers
Disposal of your old appliance
1.When this crossed-out wheeled bin
symbol is attached to a product it means
the product is covered by the European
Directive 2002/96/EC.
2.All electrical and electronic products should be disposed of
separately from the municipal waste stream via designated
collection facilities appointed by the government or the
local authorities.
3.The correct disposal of your old appliance will help prevent
potential negative consequences for the environment and
human health.
4.For more detailed information about disposal of your old
appliance, please contact your city office, waste disposal
service or the shop where you purchased the product.