16
Settings for Word Sync, Volume and i.LINK
INPUT SETUP
If you want to change “W_OUT (Word sync output
frequency)”, select an input to be changed by turning
the INPUT knob.
“W_OUT” can be set independently for each input, while
“S_VOL” is applied to all inputs.
Repeatedly press the SETUP button to select the menu
item to be changed.
If you leave the unit idle for 10 seconds, the setup mode will
be cancelled.
Turn the INPUT knob to select the options within the
menu item.
<
Repeat steps and as required.
Repeatedly press the SETUP button (or leave the unit
idle for 10 seconds) to exit the setup mode.
<
Settings are stored even when power is turned off and the
unit is unplugged. If left unplugged for an extended period,
the settings may be lost.
4
32
3
2
1
Available menu item and options
W_OUT (Word sync output frequency)
Select the frequency of the word sync signal. The factory
setting is “100”.
100 aq 44.1 aq 88.2 aq 176(176.4) aq 48 aq 96 aq 192
<
The word sync signal is output only when the WORD button
is set to “W`_OUT” (see page 13).
S_VOL (starting volume)
OFF (default)
The unit turns on with the last volume adjusted by the
VOLUME knob.
“- - -” to “–20dB”
The unit always turns on with the volume you set here.
The level can be adjusted in 1 dB steps from - - - (–
∞: no
sound) to –20 dB.
“CH” and “i_RC” (settings for i.LINK) will be added after a
future hardware upgrade (charged).
(Normal display)
Select this to exit the setup mode.