Filter
Top Products
15
ENGLISH
The names of the inputs shown on the display can be changed.
You can also set the INPUT knob to skip the input terminals that
are not in use.
Example:
When a CD player is connected to the COAX (coaxial) terminal
and a DVD player to the OPT (optical) terminal
Select “CD” for COAX.
Select “DVD” for OPT.
Select “*skip” for other terminals.
Then only “CD” or “DVD” will appear on the display when you
turn the INPUT knob.
Press and hold the SETUP button for more than 2
seconds.
The unit enters setup mode, and “L-1>
***
” appears on the
display. (
***
changes depending on your setting.)
If the INPUT knob is set to LINE (1, 2, 3 or 4) or PHONO,
“GainL
*
>
***
” will appear instead of “L-1>
***
”. In this
case, lightly press the SETUP button again to show “L-
1>
***
”.
If you leave the unit idle for 10 seconds, the setup mode will
be cancelled.
Repeatedly press the SETUP button to select the input
terminal to be changed.
L-1 (LINE1) q L-2 (LINE2) q L-3 (LINE3)
q
L-4 (LINE4) q i-L (i.LINK)* q C-1 (COAX)
q
O-1(OPT) q (normal display)
q
L-1(LINE1) q
*: “i-L” will be added after a future hardware upgrade
(charged).
2
1
Name and Skip Setting of the INPUT Knob
Turn the INPUT knob to change the setting.
Default name, CD, SACD, DVD, TUNER, MD, CD-R, TAPE,
PHONO, MP3, TV, SAT, CATV, DVD-R, VCR, *skip
< The default name of the LINE4 terminal depends on the
LINE4/PHONO switch.
When the LINE/PHONO switch is set to LINE, the default name
is “LINE4”. When the LINE/PHONO switch is set to PHONO,
the default name is “PHONO”.
<
Skip function will not work at all if you set all the input
terminals to “*skip”.
< The name of the i.LINK terminal cannot be changed, as the
display always shows model name of the connected device.
Only “*skip” is selectable for i.LINK.
Press and hold the SETUP button for more than 2
seconds (or leave the unit idle for 10 seconds) to exit
the setup mode.
<
Settings are stored even when power is turned off and the
unit is unplugged. If left unplugged for an extended period,
the settings may be lost.
4
3
INPUT SETUP