Filter
Top Products
PAGE 80
FireBall™ SE-D1 User’s Manual
RESTARTING THE SYSTEM
There are two ways of manually performing a full restart or reboot of the FireBall system, one using
the front panel power button and the other using the Restart System menu.
Follow these steps to restart the system using the front panel Power Button:
1. Press and hold the power button for 4 seconds.
2. When the LED on the front panel begins to flash, release the power button.
3. When the LED on the front panel glows solid RED (standby mode), FireBall is
ready to use.
4. Press and release the Power button to turn on FireBall.
Follow these steps to restart the system using Utilities menu:
1. Press the SETUP key on the remote to display the Setup menu.
2. Select the UTILITIES menu.
3. Select the RESTART SYSTEM menu.
4. Confirm that you want to restart the system and select the RESTART button.
5. When the LED on the front panel glows solid RED (standby mode), FireBall is
ready to use.
6. Press and release the Power button to turn on FireBall.