Ericsson RX8315 Home Theater System User Manual


 
Quick Start Guide: Connect-Power-Configure
8. Set the set the LNB power output level
A description of each of these User Settings can be found in the Reference Guide.
Note: If the unit has successfully locked to the incoming feed, then the TS Lock
value in menu Input should be LOCKED.
3.4 Selecting a Decode Service (Program)
To select a decode service:
1. Navigate to the Service menu. For incoming feeds containing only a single
service the service may be selected automatically depending on service
selection control.
2. If the service is NOT selected, press Edit and, using the S (Up) and T (Down)
pushbuttons in the decode service sub-menu, scroll through the service name
list.
3. Press Save to select the required service.
Note: If the unit has successfully selected a service, then the Service ID and
Service name should be displayed in the Service menu.
3.5 Configuring the Video Output
When configuring the Video Output, the following points should be observed:
The unit will automatically decode the first video component that it finds within
the selected service.
An alternative video component may be selected from the service tab on the
Web Control interface.
If the incoming video is successfully decoded then the status OK should be
displayed on the appropriate page.
Successfully decoded High Definition video will be output from the connector
marked Video Component.
Successfully decoded Standard Definition video will be output from the
connector marked CVBS.
3.6 Configuring the Audio Outputs
When configuring the Audio Outputs the following points should be observed:
The unit will automatically decode the first two audio components that it finds
within the selected service.
EN/LZT 790 0008/1 R1A 2011-03-30
14 (40)