Filter
Top Products
42 Making Detailed Adjustments
■ Auto Iris
When this setting is on, the light output is automatically adjusted according to the
brightness of the image. Select either
Normal or High Speed to indicate how quickly
you would like the projector to respond to changes in the brightness of the image. The
setting is stored separately for each image source and color mode.
It is best to use
High Speed for content that frequently changes from bright to dark
images. Normal can be used for all other content.
■ Setup Level
Note: This setting can be used only when an NTSC (480i) signal is being input through the
Video port, or when a video signal is being input through the Component video ports.
This setting adjusts the threshold at which dark areas of the image are rendered black
(0 IRE). For compatibility with most DVD and video equipment sold in the United
States, leave this setting at 0%. Check your video equipment’s specifications to be sure of
the correct setting.
■ EPSON Super White
Note: This setting can be used only when the signal is input through the, WirelessHD, HDMI1
or HDMI2 ports with the Color Mode set to Natural, THX, THX 3D, Cinema, or 3D Cinema (see
page 34).
If bright parts of the image are washed out or overexposed (when the input signal
contains values over 100 IRE), turn this setting on to compensate.
■ HDMI Video Range
Note: This setting can be used only when WirelessHD, HDMI1 or HDMI2 is selected as the
image source (see page 24). This setting cannot be used when Epson Super White is set to
On.
If your video equipment has an HDMI port and you’ve connected it to the projector
using an HDMI cable, set the level of the projector to match that of the video equipment.
Image > Auto Iris
Signal > Advanced > Setup Level
Image > Advanced > EPSON Super White
Signal > Advanced > HDMI Video Range