Filter
Top Products
48 Maintenance
Cleaning the Projector Case
Before you clean the case, turn off the projector and unplug the power cord.
■ To remove dirt or dust, wipe the case
with a soft, dry, lint-free cloth.
■ To remove stubborn dirt or stains,
moisten a soft cloth with water and a
neutral detergent. Then wipe the case
and dry it with a dry cloth.
Caution: Never use wax, alcohol, benzene,
thinner, or other chemical detergents. These can damage the case.
Cleaning and Replacing the Air Filter
Your projector includes an air filter to ensure the best performance. If dust collects on the air
filter on the bottom of the projector, clean it as described below. Dust clogs prevent proper
ventilation and cause overheating and damage to the projector.
1. Press the P
Power button and wait for the PPower light to stop flashing. The projector
cools down.
2. Turn off the projector using the power switch on the back.
3. Unplug the power cord and disconnect any cables.
4. Use a small vacuum cleaner that is designed for computers
and other office equipment to clean the filter on the
bottom of the projector, as shown. If you don’t have one,
gently clean the filter using a very soft brush (such as a
clean artist’s paintbrush).
If the dirt is difficult to remove or the filter is broken,
replace it. You can purchase air filter part number
V13H134A09 from an authorized Epson reseller. To find
the nearest reseller, please call 800-GO-EPSON
(800-463-7766). To purchase online, visit
www.epsonstore.com (U.S. sales) or www.epson.ca
(Canadian sales).
PowerLite Home Cinema 1080.book Page 48 Tuesday, February 5, 2008 4:46 PM