Filter
Top Products
Making Detailed Adjustments 45
■ Component
Change this setting to match the type of equipment connected to the Component port.
For component video, select
Auto to let the projector automatically interpret the signal;
or select
YCbCr or YPbPr to manually select your video equipment’s signal.
■ Trigger Out
Turn on this setting if you want the Trigger out port to output a 12-volt signal while
the projector is operating. You can use this to raise or lower your projection screen.
■ Sleep Mode
Turn off this setting if you don’t want the projector to enter sleep mode. (Sleep mode
shuts the projector off automatically when there is no video signal.)
Select
5min., 10 min., or 30 min. as the length of time before shutoff; decreasing the
time conserves power and extends the life of the lamp.
To turn the projector back on, press the
On button on the remote control, or press the
P
Power button on the projector.
■ Child Lock
Lets you lock the PPower button on the projector’s control panel to make it more
difficult for a child to turn on the projector. See page 32 for more information.
■ Operation Lock
Lets you disable all the buttons on the projector’s control panel to prevent the image from
being accidentally changed once it is adjusted. See page 32 for more information.
■ High Altitude Mode
Adjusts the speed of the fan so it can properly cool the projector at altitudes above
4900 feet (1500 meters).
Settings > Input Signal > Component
Settings > Trigger Out
Settings > Sleep Mode
Settings > Child Lock
Settings > Operation Lock
Settings > High Altitude Mode
PowerLite Home Cinema 1080.book Page 45 Tuesday, February 5, 2008 4:46 PM