Filter
Top Products
10
Figures in this section provide the guidelines for wiring
the 396P-01 sensor to various Analyzer/Transmitter
instruments.
To determine which wiring guideline to use, locate the
model number of the sensor to be installed.
1. If the cable needs to be extended, use a high qual-
ity eleven conductor double shielded instrument
cable available from Rosemount Analytical. Refer
to Table 3-1 for the appropriate junction box to use
and the corresponding wiring details.
NOTE
If the cable is too long, loop up the excess
cable. If the cable has to be shortened, cut
and terminate each conductor neatly and
make sure that the overall (outermost)
drain wire is not shorted out with either
of the two inner drain wires (shields).
2. Signal cable should be run in a dedicated conduit
(preferably an earth grounded metallic conduit)
and should be kept away from AC power lines. For
your convenience, a wire nut kit is furnished (in a
plastic bag wrapped around the cable).
NOTE
For maximum EMI/RFI protection when
wiring from the sensor to the junction box,
the outer braid of the sensor should be con-
nected to the outer braided shield of the
extension cable. The outer braid of the
extension cable to the instrument must be
terminated at earth ground or by using an
appropriate metal cable gland fitting that
provides a secure connection to the instru-
ment cable.
Preamplifier Location Analyzer/Transmitter
Sensor Integral to Integral to Remote Interconnect 1054A, 54e, 81, 1055 1181 1050 1003 SCL or Refer to
Model Sensor Analyzer Junction (unprepped 1054B, 2054 3081, 1060 1023 SoluCube Figure
Options
Box (PN) PN) 2081 4081, 5081 #
396P-01-()-50 ✓ ✓✓ 3-2
396P-01-()-50 ✓ Ext. box 9200254 ✓✓ 3-2
(22719-02)
396P-01-()-54 ✓✓ 3-3
396P-01-()-54 ✓ Ext. box 9200254 ✓ 3-3
(22719-02)
396P-01-()-55 ✓✓3-5
396P-01-()-55 ✓ Ext. box 9200273 ✓ 3-4
(23550-00)
396P-01-()-55 ✓ 9200273 ✓ 3-6
or 23646-01
TABLE 3-1. Wiring Matrix Guide
MODEL 396P and 396PVP SECTION 3.0
WIRING - MODEL 396P
SECTION 3.0
WIRING — MODEL 396P-01