Filter
Top Products
6
OPERATING INSTRUCTIONS
LISTENING TO THE RADIO
Notes:
• Make sure that the FM antenna is extended to its full length.
• Make sure that the FM MODE switch (on the back cabinet) is set to the STEREO
position.
1. Set the Function selector to ‘RADIO’.
2. Set the Band selector to the desired band, ‘AM’ or ‘FM’.
3. Press the POWER button to turn the unit ‘On’.
4. Tune to the desired station with the TUNING knob.
Note: If you tune to an FM station which is broadcasting in stereo, the FM STEREO
LED indicator comes on.
5. Adjust the VOLUME control to the desired level.
6. When you are finished listening, press the POWER button again to turn the unit
‘Off’. The POWER LED indicator goes off.
HINTS FOR BETTER RECEPTION
FM: The FM lead wire antenna on the back panel should be extended to its full
length. You may also have to vary the direction of this antenna until you find
the position that provides the best reception.
AM: The AM bar antenna is inside the cabinet of the main unit. You may need to
change the position of the main unit until you find the position that provides the
best reception for your favorite AM stations.