Filter
Top Products
21
Setting The Clock
When the system is connected to an AC outlet
the time display will show “AM 12:00”.
NOTE: Although it is not necessary to set the clock in order to listen to the
Radio or CD player, the clock must be set correctly if you intend to use the
timer to turn the system ‘On’ and ‘Off’ automatically.
Set the clock as follows:
1.) Press the MEMORY(CLK. ADJ.) button on
front panel or MEMO(PROG) button on
remote control once. The ‘Hour’ digits begin
flashing.
2.) Repeatedly press the or buttons on
front panel, or remote control to adjust the
display to the correct hour, AM or PM.
3.) Press the MEMORY(CLK. ADJ.) button on
front panel or MEMO(PROG) button.
The ‘Minute’ digits begin to flash.
4.) Repeatedly press the or buttons on front panel, or remote control to
adjust the display to the correct Minute.
5.) Press the MEMORY(CLK. ADJ.) button on front panel or MEMO(PROG) button
on remote control again.
Only the colon “ : ” continues flashing.
The clock begins to run.
NOTES: The display will always show the time when the system is in the
Standby (Off) or AUX mode.
MS3111M_112306.p65 23/11/2006, 10:4421