Filter
Top Products
December 2014
2
Quick Start Guide
©
NOTICE
This installation guide provides basic guidelines for the Rosemount 3107 and
Rosemount 3108. It does not provide instructions for detailed configuration, diagnostics,
maintenance, service, troubleshooting, or installations. Refer to the Rosemount 3107 and 3108
Reference Manual (Document Number 00809-0200-4840) for more instructions. Manuals are
available electronically on www.rosemount.com.
Failure to follow these installation guidelines could result in death or serious injury
The Rosemount 3107 and Rosemount 3108 are ultrasonic transmitters. They must be
installed, connected, commissioned, operated, and maintained by suitably qualified
personnel only, observing any national and local requirements that may apply
Use the equipment only as specified. Failure to do so may impair the protection provided by
the equipment
Explosions could result in death or serious injury
Installation of the transmitters in a hazardous environment must be in accordance with the
appropriate local, national, and international standards, codes, and practices. Please review
the Product Certifications section for any restrictions associated with a safe installation
Before connecting a Field Communicator in an explosive atmosphere, ensure the instruments
are installed in accordance with intrinsically safe or non-incendive field wiring practices
Verify that the operating atmosphere of the transmitter is consistent with the appropriate
hazardous locations certifications
External surface may be hot
Care must be taken to avoid possible burns
Process leaks could result in death or serious injury
Install and tighten process connectors before applying pressure
Do not attempt to loosen or remove process connectors while the transmitter is in service
Electrical shock could cause death or serious injury
Make sure that the transmitter is not powered when making connections
If the liquid level switch is installed in a high voltage environment and a fault condition or
installation error occurs, high voltage may be present on leads and terminals