Filter
Top Products
23
Owners Manual
Edit
Both Factory and User preset can be edited, but edited presets can only be stored
in User preset locations.
Standard Edit Mode
The DC-One defaults to Standard Edit mode wherein, input and output channel
parameters are appropriately linked. (Refer to “Configurations” illustrations to see
which channels are parameter-linked for each configuration.
Linked parameters are always identical in value. For instance, setting a graphic eq
curve for Input A, sets the same curve for Input B, if the configuration has linked
stereo inputs. Either input channel can be edited; changes will be reflected in
both. The same is true for parameters of linked output channels. The only
exception to the linking of parameters is the Mute buttons. Output channels can
be individually muted at any time, either from the DC-One front panel or the
Graphic User Interface application.
Full Edit Mode
In the Setup menu, the edit mode can be
changed to Full Edit. In Full Edit, no parameter
links are enforced, regardless of the
configuration selected. Any parameter can be
changed without any effect on other parameter values.
Regardless of the edit mode selected, there are
two means to enter edit mode: pressing the Edit
button or pressing any DSP block button.
Use the < Select > buttons to navigate to the top
line of any edit screen, and the Value Up and
Down buttons to navigate to any other Edit
screen. As a short-cut, press a DSP block button to jump to the last selected
screen of said block and navigate as above to reach the desired screen.
Parameters
The following section is a detailed description of every DSP parameter available in
the DC-One; grouped by DSP block, in order of the signal flow of the DC-One.
Not all parameters may be accessible in every preset and, depending on the
configurations set by the contractor/installer, not all presets and/or preset values
may be available for editing. Changes to preset availability, parameter availability
and preset value ranges can only be set using the DC-One Editor PC application.
Level
PEQ
PEQ
( Repeat press for next channel )
PROCESSING MENUS
Delay
OUTPUT
INPUT
X-Over
HPF
GEQ
Delay
Input A&B DSP Block
Output 1-6 DSP Block