Filter
Top Products
2. Attach the Wall Brackets to structure. You must provide attachment
hardware and ensure the attachment method and structure are
capable of supporting the intended load. Position the Wall Bracket
weld nuts left or right to allow clearance for later insertion of the
Retainer Bolt.
3. Ensuring they are oriented properly, install the two Enclosure
Brackets on the loudspeaker. Insert and hand-tighten the supplied 3/8-16
Enclosure Bracket Bolt and Lock Washer for each Enclosure Bracket.
4. Lift the enclosure onto the installed Wall Brackets.
WARNING: Use at least two people for lifting enclosure onto the
brackets.
5. Insert and snugly tighten at least one of the supplied 1/4-20 Retainer
Bolt and Lock Washer through the side of either of the Wall and
Enclosure Brackets. This prevents the enclosure from being lifted off
the Wall Brackets.
6. Securely tighten each 3/8-16 Enclosure Bracket Bolt to lock the
enclosure at the desired horizontal angle.
3.7 Signal Processing
The vertical coverage is determined by programming the loudspeaker’s
digital signal processing.
Use the DSAPilot to determine the desired coverage. The DSAPilot calculates
and optimizes the signal processing required to achieve the desired results.
High pass/low pass filters, parametric EQ, delay, and gain are user adjustable
for each of the two inputs.
10
1/4-20 X 3 LG
HEX HEAD
RETAINER BOLT
& LOCK WASHER
2X 3/8-16 X 2 LG
BLACK HEX HEAD
ENCLOSURE BRACKET
BOLT & LOCK WASHER
2X ENCLOSURE
BRACKET P/N 0006118
2X WALL BRACKET
P/N 0006119
Figure 3.6.2a Bracket Installation
Figure 3.6.2b Installed Bracket
Figure 3.7 DSAPilot Main Screen