Filter
Top Products
AC outlets on the same circuit breaker
Power strip
Tape Deck
DVD
Pre-amplifier
Amplifier
Subwoofer
Connections
• This diagram shows all the low power components
Please consider the following when setting up
sharing a power strip which is connected to the same
your new system:
outlet used by the amplifier.
• Before making or changing any connections,
• The subwoofer is connected to an outlet on the
ALWAYS make sure that the subwoofer is unplugged
same circuit breaker, provided that the total system
from the wall and your other components are turned
current draw does not exceed the breaker current
OFF. Also, turn down the volume control of the
rating.
subwoofer and your pre-amplifier or receiver.
• This arrangement will reduce the possibility of an
audible hum in your system caused by a ground loop.
• Whenever possible, keep the power cords away
from the signal cable or speaker wires to prevent any
hum or inference being heard in speakers.
• Choose reliable, high quality interconnect cables,
also called patch cords or RCA cables. They should
be fully shielded and as short as possible for the job.
The longest cable in your system will likely be to the
subwoofer, so choose a good quality brand.
• Some patch cords can be a very tight fit and there is
usually a preferred method of getting them off. Some
have to be removed with a twisting action. Be gentle
or you may damage the jacks of the subwoofer or
your other components.
Speaker Level Connections
• The subwoofer's Speaker Level Inputs can accept
speaker stripped speaker wires only.
• Make sure that the negative speaker wires never
touch the positive wires as this will short out and
possibly damage your amplifier or receiver.
Earthquake • MiniMe User Manual
8