Earthquake Sound P10 Speaker User Manual


 
Earthquake Sound, 2727 McCone Avenue, Hayward, CA 94545 USA
www.earthquakesound.com
VOLUME
FREQUENCY
MODE
PHASE
AUTO
MIN
50Hz
MAX
RIGHT
POWER
LEFT
160Hz
SUB
0
OFF
LFE
180
ON
110-120VAC~60Hz
220-240VAX~50Hz
FUSE: 115V, T6.4AL/250V
FUSE: 230V, T3.2AL/250V
ON
110-120V
220-240V
OFF
TO REDUCE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
WARNING
WARNING: SHOCK HAZARD-DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
P O W E R
DIGITAL
600 WATTS
POWERED
SUBWOOFER
FUSE
Using the line speaker-level inputs
If you are using a receiver which does not have a
subwoofer output or line level outputs (pre-outs), you
can connect its speaker outputs to the subwoofer's
Speaker-Level inputs. The front speakers can still be
connected to your receiver.
The subwoofer's internal amplifier supplies the power
to reproduce the low frequency range. It receives a
sample of the signal going to your front speakers. (An
insignificant fraction of your receiver's power is
transferred to the subwoofer).
There is no need to use the Speaker Level inputs if
you are using a separate amplifier and pre-amplifier.
Such systems are best connected using the Line
Level Inputs as shown in the previous diagrams.
If you are using the Line Level inputs and there is an
excessive amount of noise or hum present, using the
Speaker Level inputs may yield a lower background
noise level.
Earthquake • MiniMe User Manual
12
FRONT
SPEAKERS
FRONT
SPEAKERS
+ -
RECEIVER
MAIN
OUTPUTS
L R
+ -