Filter
Top Products
(6) Auto ON/OFF (10) Sub Operation Switch
When the main “POWER” ON/OFF switch is in the In LFE position, the Frequency adjustment becomes
“OFF” position, this switch has no affect on the disabled and the subwoofer runs in a Full range
subwoofer. When the main “POWER ON/OFF” switch mode, from 20Hz - 2kHz.
is in the “ON” position, this switch allows the auto
circuit to be engaged. When this switch is in the While in Sub position the subwoofer reverts to the
“AUTO” position, the subwoofer will automatically turn manual frequency adjustment, allowing the user to
“on” when it senses a signal. It will automatically turn operate and fine tune the subwoofer to their personal
“off” after 20 minutes with no signal. When this switch taste.
is in the “ON” position, the subwoofer will remain on
as long as the “POWER” ON/OFF switch is in the (11) 50Hz - 160Hz Frequency Adjustment
“ON” position. This controls the high frequency cutoff point. With the
control set to the middle, the subwoofer will reproduce
(7) 110-120V AC Power Connection frequencies up to 105Hz. If the control is set fully
The Earthquake MiniMe is equipped with a built in clockwise, the crossover is bypassed and the
standard, two-prong power connection. subwoofer will reproduce a wide frequency range.
With the control fully counter-closkcwise the
(8) Power Status LED subwoofer reproduces a narrow range, up to 50Hz.
Earthquake powered subwoofers have an LED on the
panel that indicates the status of the built-in amplifier. Rotate the control until the bass sound natural. If the
The LED will light red when the amplifier is in standby mid-bass sounds natural but you want more low bass,
mode and green when the amplifier is on and turn the control down a little.
receiving a signal.
(12) Volume Control
(9) 0-180° Phase Shift Manual volume control to regulate your subwoofers
This control is used to acoustically match the power output, to prevent clipping and distortions
subwoofer’s output to your main speakers. Select the caused by overpowering.
position, either 0° or 180°, in which your subwoofer
has more output at the listening position.
inspecting or changing the fuse. Never
use a fuse with a larger current rating
than recommended.
Always unplug the power cord before
Earthquake • MiniMe User Manual
6
Control Panel Overview Continued