Filter
Top Products
Phoenix type connector
Should be wired using CAT5 or 5e, CAT6 or 6e.
This allows zone control via IR. This must be
connected to the zone pad.
BUS section ExplainedAmplifier section Explained
Bus Control Limiter (BCL)
It controls the front pad maximum output power
from over powering small speakers. The module
BCL would limit the output power of any amplifier
that uses the bus as a signal source.
L
R
L
R
Bus RCA input signal
Stereo input signal RCA that delivers the signal to
the bus. It also allows you do daisy chain the
signal to additional Cinénova amplifiers.
DC TRIGGER
12 Volt DC trigger to be connected to source
output 12 volt trigger. For this to operate, you need
to switch the front panel switch to OFF.
4 IR repeater
The Cinénova-IR16 has four output IR that
combine any or all zone IR input. These repeater
will repeat the sum of IR signal to control any
source input. Please note that you will need to use
your source remote, aim it at the pad and it will
deliver the IR signal to the source.
Mono/ Stereo input control
You must switch to MONO when the amplifier
is wired for MONO
L
R
Input Signal Control(ISC)
When switched to LOCAL, individual
inputs will drive each individual
amplifier.
When selecting BUS, the audio
input from the BUS will drive the
amplifier.
Speaker output terminal
For stereo applications, please follow the
polarity that is shown on top. For MONO
follow the bottom polarity.
Please note that FFI is a Fault Fuse
Indicator. Any amplifier that has the FFI
LED light on will require a fuse replacement
or possibly service.
L
M
R
-
Keypad Front view
Keypad Rear view
Rear Gain Control Limiter (RGCL)
It controls the front pad maximum output power from over
powering small speakers. The module RGCL will limit the
output only when the RCA input selection is set to MAIN
(not Bus).
L
M
R
L
M
R
L
M
R
L
M
R
L
M
R
L
M
R
L
M
R
L
M
R
SPEAKER OUTPUT
L
L
L
L
L
L
L
L
R
R
R
R
R
R
R
R
L
R
L
R
FUSE
110-120VAC-60Hz
220-240VAC-50Hz
Earthquake Sound
14
Features Explained