Filter
Top Products
Cin ova-IR16 Power Amplifierén
Special Features
Eight individual power supplies:
Rack mountable:
The Cinénova-IR16 is designed with 8 individual power
supplies(bifilar) for power isolation, accuracy and better channel This amplifier is designed to conveniently mount in commonly
separation. used racks.
Peak LED indicators: 110V AC and 220V AC selectable:
The Cinénova-IR16 is equipped with 16 LED indicators on the The Cinénova-IR16 is factory preset to 110-120VAC. However,
front panel. They show the operating status of each channel; the LEDs it can also be set to accommodate 220-240VAC by Earthquake
will illuminate when the maximum recommended output is exceeded. authorized technician(s)/dealer(s).
If an LED is illuminated the majority of the time, it indicates that the
corresponding channel is over-driven (clipped). The input to the Remote zone control:
channel must be reduced to eliminate distortion and eventually,
damages to the amplifier. Each of the eight possible zones can be controlled by a wireless
IR remote control. Each remote has the ability to control volume’s
Thermal protection: up/down level, mute and also repeat the IR signal to other sources.
Each channel is equipped with a thermal sensor designed to Bus input:
shut the amplifier down when it overheats. Overheating is not typical. It
only occurs if the amplifier is over driven with low impedance speakers, This feature simplifies installation by consolidating several
or if the amplifier is located in an improperly ventilated space. channels for one source. Simply plug the input source RCAs into the
BUS input on the unit. Then switch the input source selector to BUS for
Individually selected and matched components: as many channels are connected to the corresponding input source.
Components used to construct the Cinénova-IR16 are Bridgeable function (minimum impedance = 4-ohm):
subjected to an exhaustive selection process; during which, the
components are matched and individually tested to exact tolerance. The Cinénova-IR16 delivers up to 8-zones, and can be bridged
The multi-layer, glass-epoxy, double sided printed circuit boards into several different configurations for higher power rooms.
exceed the standard stringent requirements by 50%.
4 or 8-ohm compatible:
8-Zones: Since speakers are manufactured in several different
impedance ratings, Earthquake Sound’s Cinénova-IR16 amplifier is
The Cinénova-IR16 delivers up to 8-zones, and several other designed to be 4 and 8-Ohm compatible.
room combinations to better suite the your needs.
Special Features
13