Filter
Top Products
6 Dynaudio Sub 600
BEFORE OPERATION
Unpacking
To find the suitable position for the Sub 600 in your listening room, please read the
chapter “Positioning the subwoofer” on page 20.
To unpack the subwoofer
1. Unpack the subwoofer on a clean, even and soft area; floor carpeting is very suitable.
2. The packaging should be opened from the top. Remove all accessories that come
packed with the subwoofer. Do not remove the top part of the protective material.
3. With the protective material still in place but with accessories removed, carefully tilt
the packaging on its side and tilt again to turn it upside-down. Ensure that no part of
the top-cover is obstructing the opening at the top.
4. The outer packaging can now be lifted away from the subwoofer itself. Remove the
protective material that now is on top. Through the bag you can now see the
underside of the subwoofer.
5. Open the bag and remove such from around the base of the subwoofer.
6. Again, carefully tilt the subwoofer on its side and again to turn it onto its feet. Note that
the top part of the protective material will now come off easily so ensure that the
subwoofer does not drop or slide away in the process.
Check that the contents are complete
• Subwoofer: The factory-set power requirements (refer to label on rear of subwoofer)
should correspond for the region where the subwoofer was purchased. Refer also to
chapter “Important Safety Instructions” on page 2.
• Front baffle grille
• AC mains lead. The supplied lead should be suitable for the region where the
subwoofer was purchased.
• Owners Manual
1
2
3