Filter
Top Products
12 Dynaudio Sub 600
OPERATION
Connecting a single subwoofer
➊ To connect the SAT/SUB input:
From the preamplifier output of your processor/receiver, PC or mediaplayer (often
marked as Pre Out or Front Out) connect a stereo RCA cable to the subwoofer SAT/
SUB Input.
This signal should not be already processed by the processor/receiver. Please pay
attention to the settings of your processor/receiver.
➋ To connect the LFE channel:
From the processor or receiver’s low-level (not a speaker output) subwoofer output
(often marked as “subwoofer out”, “Sub out” or “LFE”), connect a mono RCA-to-RCA
cable to the subwoofer input SUB I/O - LFE/Slave IN.
This signal should not be already processed by the processor/receiver. Please pay
attention to the settings of your processor/receiver.
Set the MODE switch to LFE.
Note: You also can use both connection types. Both signals will be combined in the
Sub 600 and routed accordingly. This allows the Sub 600 to reproduce both the
LFE channel information as well as the bass range of the connected satellite
speakers
ON AUTO
GAINPOWER PHASE
SUB LowpassSAT Highpass
SAT/SUB Input SAT Output
LFE / Slave IN OUT
Flat60 Hz
LFE Slave
80 Hz
Min Max
50 Hz 150 Hz
0° 180°
LEFT
RIGHT
SUB I/O To Slave
➊
➋
LFE/SUB OutFront Out/
Pre Out