Filter
Top Products
10
Outlaw Audio
Owner’s Manual
11
Model 950 7.1 Channel Preamp/Processor
Owner’s Manual
Remote Control
The Model 950 Universal Learning Remote Control duplicates every function
available from front panel of the preamp/processor and more. It is designed
to access all the conguration and operation menus of the 950. These are
displayed on the FRONT PANEL DISPLAY of the Model 950, as well as the ON
SCREEN DISPLAY (OSD) The Remote Control contains an extensive library of
IR codes and may be programmed to operate a wide range of audio and video
components. Additionally, you can teach the remote to control other audio/video
units not included in the unit’s built-in memory by entering their particular
device codes (see page 39).
Many of the buttons on the Remote Control serve several functions, depending
on the source device being controlled. The list below describes each buttons
main functions. For a complete description of their use, please refer to the
section titled “Remote Control Setup and Operation.”
1 Status LED Indicator (see page 37)
Indicates when the remote control is in Programming or Learning mode
and ashes to indicate success or failure of these functions.
2 Source Selection buttons (see page 30)
When the Model 950 is in Standby mode, pressing one of these buttons
turns the unit on and selects that source as the current input.
If the Model 950 is already on, pressing one of these buttons selects that
source as the new input.
In both cases, once properly programmed, the remote control operates the
source device selected.
The AUD button tells the Remote to control the Model 950.
The Source button selected will light whenever you push one of the
Remote’s function buttons to indicate that you have sent a command to
that component. If the command you have pressed is one that typically is
not available on that type of unit (i.e. P SCAN on a CD player) the source
button will not light even though you have pressed that button.
3 POWER button (see page 27, 30)
Returns the Model 950 to standby mode when the unit is on.
4 MUTE button (see page 31)
Mutes the main volume of the Model 950. Does not mute the second
zone.
5 Multi-zone button (see page 36)
Press the MULTI button to call up and cycle through the Multi-zone menu
options on the FRONT PANEL DISPLAY and the OSD, if active.
6 TEST button (see page 27)
Outputs an audio test tone for calibrating and setting speaker levels.
Pressing the button again restores the audio output from the previously
selected input source.
7 TRIM button (see page 33)
Activates the Channel Trim function. Pressing the button cycles through all
the channels individually for trim adjustment 10dB above or 15dB below
the master volume setting, in 1dB steps.
Model 950 Remote Control
1
2
3
4
6
7
8
9
10
11
13
26
19
18
17
16
15
14
20
25
23
24
12
5
22
21
Remote Control